Proxxon WB 220/E Mode D'emploi page 6

Operating instructions
GB
for the WB 220/E long-
neck angle drill
Dear Customer,
Congratulations on your purchase of a
new WB 220/E, an ideal tool for use in
hard-to-reach areas. With the help of
our comprehensive line of access -
ories, you can perform a range of
oper at ions, including boring, grinding,
milling and polishing. The diecast
aluminium housing head, together
with the six supplied precision collet
chucks, per mit ultra-high precision
work, even under extreme loads.
General view (Fig. 1)
1. Adjustable speed dial
2. ON/OFF switch
3. Bow
4. Connecting cable
5. Locking button
6. Steel collet chucks
7. Union nut for collet chucks
Technical data
Motor:
Voltage:
Power consumption:
Rpm:
Weight:
Noise emission:
Vibration at handle:
- 6 -
All manuals and user guides at all-guides.com
220 – 240 V
100 watt
3,000 to 15,000/min
550 g
≤ 70 dB (A)
≤ 2.5 m/s
Accessories (included)
Collet chucks for 1.0, 1.5, 2.0, 2.4, 3.0
and 3.2 mm shanks
Operation
Clamping and replacing insert units
Unplug drill before replacing insert
units.
Never press locking button 1 (Fig. 2)
with the drill in operation.
1. Rotate union nut 2 slightly to the
left or right while simultaneously
pressing locking button 1 until it
engages.
2. Unscrew union nut.
3. Insert desired collet chuck 3 with
corresponding insert unit 4 and re-
tighten union nut.
All insert units must be tightened with
as little overhang as possible. Long
pro truding shanks bend easily and
cause untrue running.
For use in dry environments only
Protection class II device
Please do not dispose off
2
the machine!
Important
Note: