Publicité
Les langues disponibles
Les langues disponibles
APPLYING THE DRAFT
(see figure 04)
The draft is a device - consisting of two parts, A and B - which connects the door of the
Minibar to the door of the piece of furniture it is fitted into, both when opening and when
closing.
To install the draft, proceed as follows:
- screw the part A onto the door of the Minibar;
- open the door of the Minibar by 90°;
- screw the part B, perfectly horizontal, to the inside of the leaf of the piece of furniture,
and fit it into the part A so it can work as a sliding guide.
CHANGE THE OPENING DOOR DIRECTION
In the niche versions, the door can be hooked onto the leaf of the cabinet housing through
the drawing line which allows for simultaneous opening (dragging system). If the door
opens in the opposite direction from the leaf of the cabinet, proceed as follows:
•
unscrew the screws which fasten the plate A to the structure of the refrigerator;
•
take the bush with the pin B and the open bush C out from their plates and exchange
their position;
•
take the pin D out from its seat and fit it into the opposite one;
•
fit the top pin into the hole of the front panel E opposite its previous position;
•
put the plate A back using the relevant screws (see figure 05).
SIGNALLING DEVICE AND DOOR OPENING CONTROL
This system consists of a sensor placed in the plastic profile above the Drink door (see
figure 06).
The sensor delivers a signal based on the position of the minibar door (open or closed).
This sensor is connected to a two-pole cable coming out of the back of the minibar.
WARNING!
If the lamp (LED) and power cord is damaged, it must be replaced by the manufacturer or
its service agent or a similarly qualified person in order to avoid a hazard.
WARNING!
If you dispose the fridge, you must take off the front door.
9
Publicité
