Yamaha DVR-S150 Mode D'emploi page 25

Auto Speaker Setup (YPAO)
4
Press STANDBY/ON to turn on the
CinemaStation.
STANDBY/ON
STANDBY/ON
( )
SURROUND
NIGHT
SET MENU
TV CH
5
Press AMP, then press YPAO to start the
setup procedure.
YPAO
Test tones (the volume is adjustable) are output from
each speaker, and the display changes as follows.
Check that the speaker from which the test tone is
being output and the name of the speaker appearing
in the display are the same.
TEST LEFT
TEST CENTER
TEST RIGHT
TEST R SUR.
TEST L SUR.
TEST SWFR
22
POWER
TV
AUDIO ANGLE SUBTITLE
SELECT MATRIX 6.1 STEREO
REPEAT A-B
SW CENTER SURR
SHIFT
TV INPUT
PRESET PRESET
PTY SEEK
FREQ/RDS MODE START
ON SCREEN MENU
START
YPAO
CH CH
ENTER
STATUS RETURN
TEST
ON/OFF
TV VOL VOLUME
MUTE
AMP
AMP
DVD/CD
VCR VIDEO
OK?
6
Press YPAO once more to continue the setup
procedure.
"AUTO SETUP" appears in the display, and
measurement begins. Test tones are output from each
speaker in turn, and the display changes as follows.
TEST CENTER
TEST RIGHT
TEST R SUR.
TEST L SUR.
TEST SWFR
The progress status appears in the display as a
percentage (normally, it takes about two minutes).
If the setup procedure is successful, "YPAO ON" and
the speaker connection status appear alternately in the
display. For more information on the speaker connection
status, refer to "Speaker wiring indications" below.
If a warning is detected, "WARNING" and the speaker
connection status appear alternately in the display. For
details, refer to "Error and warning messages" (page 24).
Speaker wiring indications
2.0 F – – – : Front speakers only
2.1 F – – SW :
Front speakers and the subwoofer
3.0 F C – – :
Front speakers and the center speaker
3.1 F C – SW :
Front speakers, center speaker and the
subwoofer
4.0 F – SR – :
Front speakers and surround speakers
4.1 F – SR SW : Front speakers, surround speakers and
the subwoofer
5.0 F C SR – : Front speakers, center speaker and
surround speakers
5.1 F C SR SW : Front speakers, center speaker,
surround speakers and the subwoofer
To cancel YPAO mode during setup.
Press ON/OFF during the setup procedure.
PRESET
FREQ/RDS
ON SCREEN
START
YPAO
CH
STATUS
ON/OFF
ON/OFF
TV VOL
DVD/CD
TEST LEFT
OK?
PRESET
PTY SEEK
MODE START
MENU
CH
ENTER
RETURN
TEST
VOLUME
MUTE
AMP
VIDEO
VCR