Publicité
Les langues disponibles
Les langues disponibles
EQ
■ Audio control allows you to easily adjust the audio system to get the best possible sound
effect.
1. enter the eQ setup mode
■ Press the [SEl] key on the remote control or touch the EQ icon in the user interface and
the following interface will display on the screen.
EQ selection
EQ parameters
2. select eQ mode
■ Touch the EQ selection bar repeatedly and the EQ mode will change.
3. adjust eQ parameters
■ To adjust EQ parameters, touch and drag the EQ parameters adjustment bar.
4. adjust front/rear/left/right fader and balance
■ you can adjust front/back/left/right balance of the speaker to a desirable listening effect
according to the surroundings and your preference.
■ To adjust Front/Rear/left/Right fader and balance, touch and drag the small white point
in the Fader/balance adjustment area.
notes:
■ The unit provides some EQ modes: user, Rock, hip hop, Dance, latin, Rave, urban,
Acoustic.
■ Different EQ reflects in different bass, Treble and mid level. The parameters of the EQ
modes has been preset and you can not change them besides 'user'.
■ The EQ mode will change to 'user' automatically when you adjust the value of bASS,
TREb or miD under the modes besides 'user'.
■ The value of Sub is independent of EQ mode and can be adjusted solely.
Fader/balance
adjustment area
36
TROUBLESHOOTING
■ what appears to be trouble is not always serious. Please check the following points
before calling a service center.
Problem
unit fuse blown.
unit can not power on.
Car battery fuse blown.
lllegal operation.
battery depleted.
Remote control does not work.
battery installed incorrectly.
lmproper audio output connection.
Volume set too low.
no/low audio output.
Speakers damaged.
heavily biased volume balance.
Speaker wiring is in contact with metal part
of car.
Pirated disc is in use.
Speaker.
Poor sound quality
or distortion.
wrong connections.
Speaker is shorted.
Tel-mute malfunction.
muTE wire is grounded.
lncorrect connection.
unit resets itself when engine is off.
between ACC and bATT.
monitor does not open automatically.
TFT Auto Open is turned off.
warning information is shown at all
Parking break wiring is not correct.
times.
The color system of DVD disc does not match
the monitor.
Flashing image or interference appears
Pirated disc is in use.
on screen.
Video cable damaged.
lmproper video signal connections.
DEUTSCH
ENGL I SH
Cause
Corrective action
general
lnstall new fuse with correct rating.
lnstall new fuse with correct rating.
Reset the unit.
Change the battery.
lnstall the battery correctly.
Check wiring and correct.
lncrease volume level.
Replace speakers.
Adjust the channel balance to center position.
lnsulate all speaker wiring connections.
use original disc.
Replace speakers.
Check wiring and correct.
Check wiring and correct.
Check the 'muTE' wiring and correct.
Check wiring and correct.
TFT monitor
Turn TFT Auto Open on.
Check wiring and correct.
Adjust the color system of the DVD disc playing
back or the monitor in us.
use original disc.
Replace cables.
Check wiring and correct.
37
Publicité
