DISA S SE MBLIN G THE JUI CE R
s
S T E P 1:
Pull the pomace container out of the appliance. Remove the juice jug.
●
ST E P 2:
Open the clasp by folding it over the renitency and down to the right.
●
ST E P 3:
Lift the juicer cover with the tamper off the juicer bowl.
●
ST E P 4:
Lift the juicer bowl together with the inlying sieve off the motor unit. When
●
lifting both parts off together, you avoid injuring yourself with the sharp sieve.
To do that, firmly yank the juicer bowl up to separate it from the motor unit.
After that, you can turn the juicer bowl upside down so that the sieve falls out.
Make sure that the sieve does not fall from high up, as this will damage the
sieve as well as the surface beneath. Alternatively, you can first remove the sieve
from the juicer bowl by firmly pulling it up and out. When doing this, you must
only hold the sieve by the upper edge, as the grinding blades in the sieve are
extremely sharp and must never be touched! Then, the juicer bowl can be easily
lifted off the motor unit.
BE FO RE FIRS T US E
s
Before using your juicer for the first time, remove all potential advertisement
●
stickers and labels (except for the type plate).
Take the appliance apart as described in the section "Disassembling the juicer"
●
(see above).
Rinse all juicer parts except the motor unit with warm (not above 50 °C) water
●
and some detergent. Please be very careful not to injure yourself with the sharp
grinding blades in the sieve. For the sieve, best use the supplied cleaning brush.
Dry all parts carefully.
Wipe the motor unit clean with a soft, slightly moist towel.
●
When all parts are completely clean, assemble the juicer as described in the
●
section "Assembling the juicer" (see page 82 – 86).
GB
87