All manuals and user guides at all-guides.com
Do Not Disturb
This feature is set at individual telephones to disable (silence) an incoming
ring signal, intercom ring. When there is an incoming call or an intercom
call, the status indicators function as normal but the phone will not ring.
1. When the unit is idle, press the DND/Privacy button. The last setting is
displayed.
2. Use the VOL (- or +) button to select the duration. You may choose
from 15 minutes, 30 minutes, 45 minutes, 1 hour, or 2 hours and
increase the duration by 1-hour intervals up to 24 hours.
3. Press the SELECT soft key to confirm. The indicator (on the base) blinks
and the display shows how long the ringer will be disabled.
4. To cancel, press DND/Privacy button again.
NOTE: If Intercom Auto Answer is activated, the unit automatically answers
the intercom call even if the Do Not Disturb function is activated.
Flash
Use the Flash button to activate custom calling services such as call waiting
or call forwarding, which are available through your local phone company.
Inserting a Pause in the Dialing Sequence
Press the #pause button twice to insert a delay in dialing sequence when a
pause is needed to wait for a dial tone (for example, after you dial 9 for an
outside line, or to wait for a computer access tone.) Each pause counts as
one digit in the dialing sequence, and is shown as "P" in the display.
Redial
1. Press the Talk button, or press the Speaker button (speakerphone mode),
or press the Headset button (headset mode) and the first available line
will go off hook. If both lines are available, Line 1 will be used.
-OR-
Press a Line button to select a line.
2. Press the Redial button. The redial number list (last 3 previously dialed
numbers) is shown.
3. Use the VOL (- or +) button to select the number. Press the DIAL soft
key to dial out the number.
NOTE: The Redial function will not operate if the number to be redialed
contains more than 32 digits. If the number is longer than that, you will
hear an error tone.
Telephone Operation
2