RugDoctor Might PRO X3 Mode D'emploi page 7

Before You Begin
Always use Anti-Foam with Upholstery
Cleaner to prevent excess sudsing in the
recovery tank. If the Rug Doctor machine
ingests foam through the dome filter,
damage to the carpet and vacuum motor
could result.
Set Up
Prepare surfaces for cleaning by thoroughly
vacuuming or brushing. When cleaning
and drying cushions, first spread sheets or
towels on the floor as a drying surface for
the dampened cushions.
Disconnect the machine's large vacuum
hose. Reconnect the top portion to the large
vacuum hose of hand tool. Slide up the brass
"quick coupler" ring and pull out the small
solution hose (ILLUS.1).
Slide up the ring again to insert the metal
end of the hand tool solution hose. Release
the brass ring to secure. Tug gently on the
hose to make certain the connection is
secure.
Remove the recovery tank, mix Rug Doctor
Upholstery Cleaner in a clean bucket
according to label directions and pour into
Lower tank (ILLUS.2).
Add 1 to 2 oz. of Rug Doctor Anti-Foam to
recovery tank (ILLUS.3). Slip the tank back
in place and close the dome hood (ILLUS.4).
Plug in the power cord and position
the machine.
Turn on the machine by sliding the switch to
the "Tool" position on the side of the handle
(ILLUS.5).
Special Application
Rug Doctor Rug Doctor
Upholstery / Upholstery
Hand Tool Cleaner
All manuals and user guides at all-guides.com
Cleaning Upholstery
Start Cleaning
Test upholstery for colorfastness by first cleaning a
small, hidden area, then rubbing the test area with
a white paper towel. If no color appears, continue
cleaning. A little color on the towel means there's
some chance of color running, but it's likely you can
still clean safely. Try using cool or cold water and test
again with a white paper towel.
Working at a slow, steady pace, begin cleaning by
squeezing the hand tool lever as you pull the tool over
fabric (ILLUS.6). Overlap strokes slightly.
As you clean, with the vacuum on, squirt or vacuum a
small amount of Rug Doctor Anti-Foam into the small
(vacuum) opening of the hand tool every few minutes
to minimize suds buildup in the vacuum hose.
If foam builds up around the hand tool, pull slightly
faster or vacuum excess solution by passing over
area a second time without squeezing the lever on
the hand tool. When cleaning is complete, switch the
machine to "0" for the off position.
Disconnect both of the hoses from the machine.
Holding the hose ends over a sink, squeeze the hand
tool trigger until all liquid is drained.
To drain and clean the machine, refer to the
Maintaining Your Rug Doctor Machine section.
Reconnect the machine vacuum and solution hoses.
NOTE: For velvet upholstery, fluff up damp pile with a
soft brush or towel to keep from matting.
Rug Doctor
Anti-Foam
(ILLUS.1) (ILLUS.2)
(ILLUS.3) (ILLUS.4)
(ILLUS.5) (ILLUS.6)
7