RugDoctor Might PRO X3 Mode D'emploi page 5

Cleaning With Your Rug Doctor Machine And Products
Read all instructions completely before you begin. To assure proper results, test carpets and
upholstery for colorfastness. Wet an inconspicuous area with a small amount of cleaner.
After 1–2 minutes, blot with a white paper towel and check for color transfer. Follow these
additional guidelines when cleaning with your Rug Doctor machine:
• Rug Doctor machines and Rug Doctor cleaning products are safe for most carpets. However, you risk damage
to carpets and hard floor surfaces not intended for water extraction method cleaning. Do not use the Rug Doctor
machine or cleaning products on natural fiber oriental rugs (silk or wool), hand-loomed wool rugs, braided rugs,
sisal or jute carpets; hardwood or laminate flooring. Some stains require professional treatment. Use cool water
when cleaning wool, wool blends or delicate fibers.
• Rug Doctor machines and Rug Doctor cleaning products are safe for many fabrics, even delicate fibers. However, you
risk damage to fabrics not intended for water extraction method cleaning. Do not use Rug Doctor machines or
products to clean fabric with cleaning codes S or X, silk, Haitian cotton, velour, brushed corduroy, leather or non-
colorfast fabrics, mattresses or mattress toppers made with memory foam, foam or goose down. Some stains
require professional treatment. Use cool water when cleaning wool, wool blends or delicate fibers.
• The machine was designed for use on carpet and upholstery applications in accordance with the instructions and
recommendations in this manual. If you use the Rug Doctor machine to clean surfaces other than carpet and
upholstery, such as hard surface floors, use only Rug Doctor recommended products. Rug Doctor Oxy-Steam
Cleaner can be safely and effectively used for either carpeting or water-safe hard surface floor coverings.
• Do NOT put bleach, dye or products other than Rug Doctor cleaners in this machine. Use of inappropriate products
may cause this machine to malfunction and may result in carpet or machine damage.
• Always use Anti-Foam with Upholstery / Hand Tool Cleaner to prevent excess sudsing in the upper recovery tank.
Foam should never be ingested through the dome filter. Damage to the carpet and/or vacuum motor could result.
•
To Reduce the Risk of Fire and Electric Shock due to internal component damage, use only Rug Doctor
cleaning products intended for use with this appliance. See the Cleaning Product section of this manual.
Afin de réduire les risques d'incendie et de décharge électrique provoqués par des composants internes endommagés,
utilisez uniquement les produits de nettoyage Rug Doctor conçus pour ce produit. Lire la section consacrée aux
produits de nettoyage dans le présent manuel.
• Avoid picking up hard or sharp objects with the carpet cleaning machine. They may damage the machine. Do not
use the machine for dry vacuuming because this machine does not have a fine dust filter. Dry vacuuming damages the
vacuum motor.
• Do not use the machine to vacuum large quantities of liquid, such as a flooded basement or large spill. This machine is
not equipped with an automatic overflow shutoff.
• To avoid damage, do not place the machine or hand tool on hardwood or laminate flooring or allow any solution or
overspray to contact such flooring.
• To avoid pump damage, do not continue to press the spray (pump) switch when the solution tank is empty.
Read instructions carefully. Rug Doctor, Inc. is not responsible for damage due to misuse of this machine.
Carpet Cleaning Tips For Best Results
• Treating difficult spots. Rug Doctor machines are designed to deep clean and extract in one cleaning pass. Your best
choice for cleaning difficult spots, stains or traffic areas is to use Rug Doctor's specialty products: Hi-Traffic Pre-
Treatment, Spot & Stain Remover, Urine Eliminator, or Odor Remover.
• Avoid over-wetting your carpet. Don't go over a heavily-soiled spot more than 2 times. Berber, Multi-Level or Looped
carpets retain more liquid. For these types of carpets, DO NOT repeat cleaning passes. If additional cleaning is desired,
allow carpets to dry before attempting to reclean heavily-soiled areas. Because they retain more liquid, Berber carpets
that are overwet can experience "wick up" of soils or spills very deeply embedded in the carpet or backing. If you
experience this problem, allow area to dry completely then clean again using single, quick passes (2 feet per second).
• Cleaning Berber carpet; You can use your Rug Doctor machine to clean Berber carpet. For best results, make only
one pass while depressing the thumb switch to release solution. Make a second pass over the same area without
pressing the switch so that you are only vacuuming the liquid. Make sure the vacuum slot at the front bottom edge
of the machine is snug against the carpet.
• Overlap passes slightly to cover all areas. IMPORTANT: When pressing the red button, keep machine moving so
vibrating brush does not agitate in one place.
• Liquid recovery. You should recover 70 - 80% of the liquid used depending on your carpet type. With Berber carpet, you
may recover a little less liquid.
• Avoid excess foam in the recovery tank which can be expelled through the machine and may affect your carpet. If
foaming occurs, add 1 to 2 oz. of Rug Doctor Anti-Foam to recovery tank.
• If you replace furniture before the carpet is completely dry, place aluminum foil under furniture legs to prevent stains.
Leave aluminum foil under furniture legs until carpet is completely dry.
• For faster drying, ventilate area. Open doors and windows. Place fans pointed downward on carpet. Turn on heat in
damp or cold weather. Turn on air conditioner in humid or hot weather. This is highly recommended when cleaning
Berber carpets.
All manuals and user guides at all-guides.com
Carpet
®
®
5