Publicité
Les langues disponibles
Les langues disponibles
operating instructions
servicing of a double
insulated appliance
In a double-insulated product, two
systems of insulation are provided
instead of grounding. No grounding
means are provided for a double-in-
sulated product, nor should ground-
ing means be added to the product.
Servicing a double-insulated product
requires extreme care and
edge of the system, and should be
done only by qualified service per-
sonnel.
Replacement parts for a double-in-
sulated product must be identical to
the original parts. A double-insulat-
ed product is marked with the words
"Double Insulation" or "Double Insu-
lated". Product may also be marked
with symbol shown below.
Do not use pressure that exceeds
the operating pressure
the parts (hoses, fittings, etc.) in
the pressurized system. Ensure all
equipment and accessories are rated
to withstand the maximum working
pressure of the unit.
Do not spray electrical apparatus
and wiring.
‧ ∙ Never disconnect the high pressure
discharge hose from the machine
while the system is pressurized. To
depressurize machine, turn power
and water supply off, then press
gun trigger 2 - 3 times.
mpx1450_en.indd 7
‧ ∙ Never permanently engage the
-
trigger mechanism on the gun.
‧ ∙ Never
without all components prop-
erly connected to the machine
(handle, gun/wand
nozzle, etc.).
‧ ∙ ALWAYS turn water supply "ON"
before turning pressure washer
knowl-
"ON". Running the pump dry
causes serious damage. The water
supply pressure must be minimum
20 psi and maximum 145 psi.
‧ ∙ Do not operate the pressure
washer with the inlet water
screen removed. Keep screen
clear of debris and sediment.
‧ ∙ NEVER operate pressure washer
with broken or missing parts.
Check equipment regularly and
repair or replace worn or dam-
aged parts immediately.
‧ ∙ Use only the nozzle supplied
with this machine.
‧ ∙ Never leave the gun unattended
while the machine is running.
‧ ∙ Never attempt to alter factory
of any of
settings.
tings could damage the unit and
will void the warranty.
‧ ∙ Always hold gun and wand firm-
ly when starting and operating
the machine.
‧ ∙ NEVER allow the unit to run with
the trigger release (off) for more
than one (1) minute. This will re-
sult in heat build-up which will
damage the pump.
∙ BEFORE SERVICING, CLEANING,
OR REMOVAL OF ANY PART,
SHUT OFF POWER AND RELIEVE
PRESSURE.
operate
the
Equipment damage.
Altering factory
mpx 1450
machine
assembly,
set-
7
22/02/10 09:29
Publicité
