Publicité
Les langues disponibles
Les langues disponibles
Page 7 of 27
•
Remove the two nuts that hold the rear OEM taillight assembly
(located on the bottom of the taillight unit) using 10mm socket and a
ratchet. Remove the OEM taillight unit.
Remove the 5 button head bolts that hold the rear mudguard (located
•
on top of the mudguard) using 4mm Allen key. Remove the rear
mudguard.
•
Remove the two plastic clips that secure the wire bundle (shown in
picture 8) using a suitable Phillip screwdriver.
Remove the spreader/location plate arrowed in picture 9.
•
Gently squeeze the indicator stem and remove the indicator with its
•
wiring.
Repeat the procedure for the other indicator.
•
Fit the original indicator to the new licence plate bracket (item 7), fit
•
the indicator adaptor (item 17) and re-fit the spreader to secure the
indicator in place.
•
Feed the indicator wires through the centre hole of the license plate
bracket as shown in picture 10.
From the kit, take the Taillight unit (Item 12) and its shroud (Item 11).
•
Insert the taillight into the shroud by aligning the two studs at the
back of the taillight into the two holes provided on the shroud. Mount
the whole assembly into the licence plate bracket (Item7) and secure
with M3 washers (Item 10) and M3 Nuts (Item 9). Tighten the M3 nuts
(Item 9)
•
Feed the wire through the centre hole on the Licence Plate bracket
(Item 7) together with the L/H and R/H Indicator wires (Picture 10).
Cut the Heat-shrink tube (Item 15) into a suitable length and feed the
•
three wires through, using a suitable heating resources, shrink the
heat-shrink tube.
•
Bring the whole assembly towards the rear sub-frame of the bike
(coming from below as illustrated on the first page of this manual).
Feed all the wires through the initial hole on the left-hand side of the
OEM undertray (arrowed in Picture 12). Support the assembly onto
the sub-frame at this stage and be aware of trapped wires. Please
make sure that there is enough slack within the wires as they can get
damaged under tension.
•
Mount the base cover plate (Item 6) below the licence plate bracket
assembly (Item 7) with its catch inserted into the centre hole located
Using the original indicators
Fitting the Taillight
LP0339
Publicité
