Publicité
Les langues disponibles
Les langues disponibles
"whistles" the setting is too lean. If there is too much exhaust
gas at the same time as the machine "4-cycles" much, the
setting is too rich. Turn the high speed needle H until the
setting sounds correct.
H
For optimum setting of the carburetor, contact a qualified
servicing dealer who has a revolution counter at his
disposal.
Correctly adjusted carburettor
When the carburettor is correctly adjusted the machine
accelerates without hesitation and the machine 4-cycles a
little at max speed. It is also important that the chain does not
rotate at idle. If the L-jet is set too lean it may cause starting
difficulties and poor acceleration. If the H-jet is set too lean the
machine will have less power, poor acceleration and could
suffer damage to the engine. If the L and H-jets are set too
rich it will lead to acceleration problems or too low a working
speed.
Starter
WARNING! When the recoil spring is wound
!
up in the starter housing it is under tension
and can, if handled carelessly, pop out and
cause personal injury. Always be careful
when changing the recoil spring or the
starter cord. Always wear protective
goggles.
Changing a broken or worn starter cord
•
Loosen the screws that hold the starter against the
crankcase and remove the starter.
•
Pull out the cord approx. 30 cm and hook it into the notch
in the rim of the pulley. Release the recoil spring by letting
the pulley rotate slowly backwards.
MAINTENANCE
•
Undo the screw in the centre of the pulley and remove the
pulley. Insert and fasten a new starter cord to the pulley.
Wind approx. 3 turns of the starter cord onto the pulley.
Connect the pulley to the recoil spring so that the end of
the spring engages in the pulley. Fit the screw in the centre
of the pulley. Insert the starter cord through the hole in the
starter housing and the starter handle. Make a secure
knot in the end of the starter cord.
Tensioning the recoil spring
•
Hook the starter cord in the notch in the pulley and turn the
starter pulley about 2 turns clockwise.
CAUTION! Check that the pulley can be turned at least a
further 1/2 turn when the starter cord is pulled all the way out.
Changing a broken recoil spring
•
Lift off the pulley. See instructions under heading
Changing a broken or worn starter cord.
•
Remove the recoil spring from inside the pulley by tapping
the pulley lightly with its inside face downwards against a
work bench or the like. If the spring pops out during fitting,
wind it up again, working from the outside in towards
centre.
•
Lubricate the recoil spring with light oil. Fit the pulley and
tension the recoil spring.
– 31
Canadian
Publicité
