7. Value Counting
The machine will total the number of bills by denomination and total value by denomination as well as a grand total.
Each denomination must be counted separately. To operate press ADD key. Then on the keypad press the denomination to
be counted ($1 - $100). After denomination is counted press the next denomination to be counted and continue until all
denominations needed to be counted is complete. Then press DISPLAY key and you can view total number of bills and
values of each denomination along with a grand total.
8. Variable Speed
The machine has three speed settings. 900, 1200, 1400 bills per minute. Use lower speed settings for older or worn bills.
To set the speed setting press menu key, 1 for Speed, then select number key 1-3.
9. This unit allows connection to a printer
Plug printer cable into printer interface on back of unit and turn printer on. The interface communication format is 8 data
bits, and white parity bit, one stop bit. Baud rate(optional): 4800bps, 9600bps, 14400bps, 19200bps, 28800bps,
57600bps. Factory defaults is 9600bps. Press " " for 2 seconds to print.
10. for Use with USA paper bills only
This unit is equipped to count USA paper bills and has Magnetic, UV and Dimension Detection Counterfeit detection feature.
Please read this section thoroughly if using this machine for the counting of US paper bills.
Important Note: Do not use this feature for Canadian Polymer or Paper bills as error messages will appear and the
Canadian currency will Jam inside the unit.
Magnetic Counterfeit Detection
If the magnetic detector does not find the presence of magnetic components that are standard in authentic bills, the
machine will stop counting to allow removal of the counterfeit bill and display the error code on the preset display. To
use magnetic counterfeit detection press menu key, 2 for Level, 2 for MG, then select number key 1-5, 1 for lowest, 5 for
highest then press Enter/Reset.
UV Counterfeit Detection
Counterfeit bills often use white or bleached paper, which will glow under ultraviolet light. To use ultraviolet counterfeit
detection press menu key, 2 for Level, 1 for UV, then select number key 1-5, 1 for lowest, 5 for highest then press Enter/
Reset. When the UV detector finds a counterfeit bill, the machine will stop counting to allow removal of the counterfeit bill
and display the error code on the preset display.
All manuals and user guides at all-guides.com
8