Using Other Functions; Setting The Audio Options - Pioneer VSX-1025 Mode D'emploi

08

Using other functions

Chapter 8:
Using other functions

Setting the Audio options

There are a number of additional sound
settings you can make using the AUDIO
PARAMETER menu. The defaults, if not stated,
are listed in bold.
Important
• Note that if a setting doesn't appear in the
AUDIO PARAMETER menu, it is
unavailable due to the current source,
settings and status of the receiver.
Setting
MCACC
(MCACC preset)
EQ
(Acoustic
Calibration EQ)
S-WAVE
(Standing Wave)
DELAY
(Sound Delay)
MIDNIGHT
LOUDNESS
b
TONE
(Tone Control)
c
BASS
70
En
What it does
Selects your favorite MCACC preset memory when multiple preset
memories are saved. When an MCACC preset memory has been
renamed, the given name is displayed.
Switches on/off the effects of EQ Pro.
Switches on/off the effects of Standing Wave Control.
Some monitors have a slight delay when showing video, so the
soundtrack will be slightly out of sync with the picture. By adding
a bit of delay, you can adjust the sound to match the presentation
of the video.
Allows you to hear effective surround sound of movies at low
volumes.
Used to get good bass and treble from music sources at low
volumes.
Applies the treble and bass tone controls to a source, or bypasses
them completely.
Adjusts the amount of bass.
RECEIVER
1 Press , then press AUDIO
PARAMETER.
Use / to select the setting you want to
2
adjust.
Depending on the current status/mode of the
receiver, certain options may not be able to be
selected. Check the table below for notes on
this.
Use / to set it as necessary.
3
See the table below for the options available for
each setting.
4 Press RETURN to confirm and exit the
menu.
Option(s)
M1. MEMORY 1 to
M6. MEMORY 6
Default:
M1. MEMORY 1
ON
a
OFF
ON
OFF
0.0 to 10.0 (frames)
1 second = 30
frames (NTSC)
Default: 0.0
MID/LDN OFF
MIDNIGHT ON
LOUDNESS ON
BYPASS
ON
–6 to +6 (dB)
Default: 0 (dB)