Professional Calibration Eq Graphical; Display - Pioneer VSX-1025 Mode D'emploi

12 Additional information
Symptom
The display shows KEY LOCK
ON when you try to make
settings.
Most recent settings have
been erased.
The various system settings
are not stored.
Professional Calibration EQ graphical output
Symptom
The EQ response displayed in
the graphical output
following calibration does not
appear entirely flat.
EQ adjustments made using
the Manual MCACC setup on
page 92 do not appear to
change the graphical output.
Lower frequency response
curves do not seem to have
been calibrated for SMALL
speakers.

Display

Symptom
The display is dark or off.
After making an adjustment
the display goes off.
You can't get DIGITAL to display
when using SIGNAL SEL.
2 DIGITAL or DTS does not
light when playing Dolby/DTS
software.
When playing Dolby Digital
or DTS sources, the receiver's
format indicators do not light.
116
En
Remedy
• With the receiver in standby, press  STANDBY/ON for about 10 seconds
while holding down SPEAKERS to disable the key lock.
• The power cord was disconnected from the wall while adjusting this setting.
• Settings are only stored if all the zones are turned off. Turn off all the zones
before unplugging the power cord.
• Do not pull out the power cord while conducting the settings. (The settings
will be stored when both the main zone and sub zone turn off. Turn off all zones
before pulling out the power cord.)
Remedy
• There are cases where the graph does not appear flat (even when selecting
ALL CH ADJ in the Auto MCACC Setup) due to adjustments made to
compensate for room characteristics to achieve optimal sound.
• Areas of the graph may appear identical (before and after) when there is little
or no adjustment needed.
• The graph may appear to have shifted vertically when comparing before and
after measurements.
• Despite level adjustments being made, the filters used for analysis may not
display these adjustments in the graphical output. However, these adjustments
are taken this into account by the filters dedicated to overall system calibration.
• Low frequencies used in bass management (the subwoofer channel) will not
change for speakers that have been specified as SMALL in the configuration,
or do not output these frequencies.
• Calibration is performed, but due to your speakers' low frequency limitations,
no measurable sound is output for display.
Remedy
• Press DIMMER repeatedly to select a different brightness.
• Press DIMMER repeatedly to select a different brightness.
• Check the digital connections and make sure that the digital inputs are
assigned correctly (see The Input Setup menu on page 43).
• These indicators does not light if playback is paused.
• Check the playback (especially the digital output) settings of the source
component.
• Check that the player is connected using a digital connection.
• Make sure that the receiver is set to AUTO or DIGITAL (see Choosing the
input signal on page 63).
• Check that the player isn't set up so that Dolby Digital and DTS sources are
converted to PCM.
• Ensure that if there are several audio tracks on the disc, the Dolby Digital or
DTS is selected.