Samsung DVD-VR330 Manuel D'instructions page 31

Setting Up the Audio
Options
Allows you to setup the audio device and sound status
settings depending on the audio system in use.
You can also adjust the NICAM mode.
1 With the unit in Stop mode/No Disc mode, press
the MENU button.
Press the ...† buttons to select Setup, then press
2
the OK or √ button.
DVD-Recorder
No Disc
Programme System
Clock Set
Setup
Language
Audio
Video
Parental Control
Install
MOVE OK
Press the ...† buttons to select Audio, then press
3
the OK or √ button.
Audio setup menu will be displayed.
DVD-Recorder
No Disc
Programme
Digital Output
DTS
Setup
Dynamic Compressiom : On
NICAM
MOVE OK
Press the ...† buttons to select the desired audio
4
option, then press the OK or √ button.
Press the ...† buttons to select the desired item,
5
then press the OK or √ button.
s
Press the RETURN or œ button to return to the
previous menu. Press the MENU button to exit
Note
the menu.
Setup
√ √
√ √
√ √
√ √
√ √
√ √
√ √
RETURN EXIT
Audio
: PCM
√ √
: Off
√ √
√ √
: On
√ √
RETURN EXIT
Digital Output
• PCM : Converts to PCM (2CH) 48kHz
audio. Select PCM when using the
Analog Audio Outputs.
• Bitstream : Converts to Dolby Digital Bitstream.
Select Bitstream when using the
Digital Audio Output.
Be sure to select the correct Digital Output or
no audio will be heard.
Note
DTS
• Off : Doesn't output digital signal.
• On : Outputs DTS Bitstream via digital output only.
Select DTS when connecting to a DTS Decoder.
When DTS soundtrack is played, sound is not
output from Analog Audio Output.
Note
Dynamic Compression
This is only active when a Dolby Digital signal is
detected.
• On : When Movie soundtracks are played at low
volume or from smaller speakers, the system
can apply appropriate compression to make
low-level content more intelligible and prevent
dramatic passages from getting too loud.
• Off : You can enjoy the movie with the standard
Dynamic Range.
NICAM
NICAM programmes are divided into 3 types.
NICAM Stereo, NICAM Mono and Bilingual
(transmission in another language).
NICAM programmes are always accompanied by a
standard mono sound broadcast and you can select
the desired sound.
• On : NICAM mode
• Off : Only set at this position to record the standard
mono sound during a NICAM broadcast if the
stereo sound is distorted due to inferior
reception conditions.
English - 31