Samsung DVD-VR330 Manuel D'instructions page 20

❚
Progressive Scan
Your TV must support progressive scan input to allow
to watch progressive scan component video out.
(See page 32)
• For more information about Progressive setting,
refer to the pages 38~39.
• Make sure that the colour coded connections
match. That is, the Y, P
jacks of your DVD Recorder & VCR should be
connected to the exact corresponding component
input jacks on your TV. Otherwise, red or blue
images will be displayed on the TV screen.
• Consumers should note that not all high definition
television sets are fully compatible with this product
and may cause artifacts to be displayed in the
picture. In case of progressive scan picture
problems, it is recommended that you switch the
connection to the standard definition output.
If there are questions regarding your Samsung TV
set's compatibility with this DVD Recorder & VCR,
please contact our customer service centre.
See your TV User's Manual to find out if
your TV supports Progressive Scan.
Note
If Progressive Scan is supported, follow the
TV User's instructions regarding Progressive
Scan settings in the TV's menu system.
Depending on your TV, the method of
connection may differ from the illustration above.
What is "Progressive Scan"?
Progressive scan has twice as many
scanning lines as the interlace output
method has. Progressive scanning method
can provide better and clearer picture quality.
You must connect the DVD Recorder & VCR
to the component(s) before using the
Progressive Scan feature.
The Component jacks will not output video
resolutions above 576p.
To view 720p and 1080i, connect the DVD
Recorder & VCR to your TV with the supplied
HDMI cable.
With HDMI connected, press the P.SCAN button
to alternate between all available resolutions.
(See page 39) (DVD-VR335,VR336 only)
20 - English
and P component output
B R
Connecting HDMI/DVI to a
TV (DVD-VR335,VR336 only)
If your TV has a HDMI/DVI input, connect the HDMI/DVI
cable to the TV. You will enjoy the best quality images
and sounds.
❚
Case 1 : Connecting to a TV with HDMI Jack
• Using the HDMI cable, connect the HDMI OUT jack
on the rear of the DVD Recorder & VCR to the HDMI
IN jack of your TV.
• Press the input selector on your TV remote control
until the HDMI signal from the DVD Recorder & VCR
appears on your TV screen.
❚
Case 2 : Connecting to a TV with DVI Jack
• Using the DVI Adapter Cable (not included), connect
the HDMI OUT jack on the rear of the DVD Recorder
& VCR to the DVI IN jack of your TV.
• Using the audio cables, connect the AUDIO (red and
white) OUT jacks on the rear of the DVD Recorder &
VCR to the AUDIO (red and white) IN jacks of your
TV. Turn on the DVD Recorder & VCR and TV.
• Press the input selector on your TV remote control until
the DVI signal from the DVD Recorder & VCR appears
on your TV screen.
To watch through the HDMI output, set the
digital audio output to PCM. (See page 31)
CAUTION
Depending on the HDMI device (TV/HDMI
Receiver) you use, audio may not be supported.
If TV does not support Dolby digital/DTS, Audio
output is not available when you set Digital
output as Bitstream or select DTS On in Audio
setup menu. In this case, set the digital audio
output to PCM or DTS off.