Fiamma Vent F Pro Instructions De Montage Et Mode D'emploi page 9

CS Návod k montáži
FR Instructions de montage
IT
Istruzioni di montaggio
Once the roofl ight installation location has been chosen, make a hole on the roof.
1
Clean the roof mounting area, which will be in contact with the seal according to the
manufacturer.
Seal the outer frame with a sealing compound (SikaLastomer710) following the proper
2
rail.
Place the upper frame in the opening hole making sure that the hinges are facing
3
towards the front of the vehicle. If necessary, press the outer frame on the roof slightly
so that the packing compound spreads out uniformly.
Place the inner frame and proceed with the installation of the roofl ight using the 11
4
supplied screws:
- Screw Ø3,5x30 mm to use for roof thickness between 28 - 44 mm.
- Screw Ø3,5x45 mm to use for roof thickness between 44 - 55mm.
Observe the recommended tightening torque Max 1.5Nm.
Install the mosquito screen in the dedicated seat with the 4 supplied screws M4x12.
5
Insert the 6 supplied pick springs in the inner frame, paying attention to place them in
6
the proper seat.
Insert the hand wheel joint on the drive shaft of the opening mechanism.
7
Mount the roller blind frame pressing on the inner frame and fi x the proper pick
8
springs, during this operation make sure that the cover of the roofl ight is perfectly
closed and in the safety position and that the hand wheel is in its seat.
Remove the protective fi lm from the cover. Do not expose the product to UV rays for
too long because it can make this operation diffi cult.
Check the product works properly.
Installation instructions
EN
ES
Instrucciones de montaje
COMFORT
9