Kenmore C970 Serie Mode D'emploi page 10

Setting Surface Controls
Models with Ceramic Glass Cooktop
(continued)
Operating the Dual Surface Radiant Element
(Models with Ceramic Glass Cooktop Only)
Model A is equipped with Dual radiant surface element in
the right front positions (See Figure 2 & 4). Models B is
equipped with a dual radiant surface element located at the
right and left front (See Figures 3 & 5) position. Turn the
knob clockwise to turn on the DUAL surface element (See
Figure 2 & 3) and counterclockwise to turn on the SINGLE
surface element (See Figure 4 & 5). You may switch from
either setting at any time during cooking.
To Operate the Dual Surface Element:
1. Place correctly sized cookware on the dual surface
element.
2. Push in and turn the control knob counterclockwise
(See Figure 1,4 & 5) for smaller cookware or clockwise
(See Figure 1, 2 & 3) for larger cookware.
3. Turn the knob to adjust the setting if needed. Start
most cooking operations on a higher setting and then
turn to a lower setting to finish cooking. Each surface
element provides a constant amount of heat at each
setting. A glowing red surface heating area extending
beyond the bottom edge of the cookware indicates the
cookware is too small for the surface heating area.
4. When cooking has completed, turn the surface control
knob to OFF before removing the cookware. Note: The
Surface Indicator light will come on when the control
knob will be turn on and will continue to glow until the
glass cooktop has cooled down to a moderate level.
The light may remain on even though the controls are
turned OFF.
Note: See page 9, Figure 1 for recommended control settings.
Radiant surface elements may appear to have cooled after they have been turned off. A hot surface
indicator light will come on and will continue to glow until the glass cooktop has cooled down to a moderate level. The
glass surface may still be hot and burns may occur if the glass surface is touched before the indicator light has turned
off.
All manuals and user guides at all-guides.com
10
Figure 1
Turn the knob clockwise to turn on the DUAL
surface element and counterclockwise to
turn on the SINGLE surface element
HOT SURFACE
Figure 2 - Model A
HOT SURFACE
Figure 3 -Model B
HOT SURFACE
Figure 4 - Model A
HOT SURFACE
Figure 5 - Model B