Trevi XR 8A30 Guide D'utilisation page 10

TWS OPERATION
This function allows you to pair 2 speakers (to be purchased separately) for stereo music
playback; This feature is only available in Bluetooth mode with compatible devices.
1. Turn off the Bluetooth function on your phone or other Bluetooth device.
2. Turn on the two XR 8A20 units and choose the Bluetooth mode.
3. Press and hold the MODE button (2) of either speaker and (a sound is heard confirming
the TWS function opened), after few seconds two bluetooth speakers make a tone, it
shows two speakers bluetooth connected.
4. Using your device to search the pairing name "XR 8A20" and enter the PIN "0000" if
required, music is ready to play for the two units together after paired.
Note: In case of non-pairing between the 2 speakers, switch off both devices and repeat
steps 1, 2 and 3.
RADIO OPERATION
Before using the Radio function, please, to insert the the charging cable into the
microUSB socket (7) as a receiving antenna.
- Turn on the speaker, press the key MODE (2) until the voice message "Radio".
- Press the Play / Pause button
stations.
- Once you have stored the stations, press the button (4) to select the next station or the
key (1) to select the previous station.
OPERATION MICRO SD CARD/ USB MEMORY
- Turn on the speaker.
- Insert a microSD card into the slot (6) holding the contacts facing upwards (the guide
entry will reproduce the message "SD Card") or insert a USB memory (the guide entry
will reproduce the message "USB").
- Playback will start automatically.
- Press once the + button (4) to skip to the next track, press once the - button (1) to
skip to the previous track.
- Press the Play / Pause button (3) to pause, to resume playback press again.
OPERATION AUX IN
- Turn on the speaker.
- Connect the Jack/Jack audio cable (supplied) to the AUX jack (9) and the other end to
the external device. The guide entry will reproduce the message "Line-In".
- Start from the external device playback.
(3) to start scanning and automatic storage of radio