LENCO PA-90 Mode D'emploi page 10

LINE IN
- Press the "Source" Button and select LINE,
LINE will show on the RED LED display.
- Plug in your 3.5mm cable into the LINE Input
on the side panel and the unit will enter into
LINE IN mode.
- You can connect any audio device that has
3.5mm audio output jack and playback any
audio from the connected device.
Recharging
- Unit comes with a battery indicator alert.
- If Battery Low LED flash, it means the battery
level is low and recharging is required.
- By connecting the AC power, the Battery Full
LED will turn RED, it means the unit is under
recharging.
- The Battery Full LED become green, it means
the level of battery is fully charged.
It is recommended to charge the battery
about 6 hours before you start using the
unit for the first time.
Caution: To keep and protect the
rechargeable battery in good condition, users
should check the unit and be sure to turn the
Power On/Off switch on the side panel to
"Off" every time after using and before
storage, it is highly recommended that users
should fully recharge the battery at least
once in every two months.
wall outlet
10
POWER
ON OFF
LINE IN DC JACK
USB Charge<1A
MIC 1 MIC 2
POWER
ON OFF
LINE IN DC JACK
USB Charge<1A
MIC 1
MIC 2