arjo Flowtron ACS900 Notice D'utilisation page 19

Mains Power
Indication
Battery Indication
Wait/Initialising
Patient Run Hours
Audible Alarm Status
The pump is connected to the mains power
supply.
The pump is NOT connected to the mains
power supply.
When the pump is connected to the mains power
supply:
• If the battery is fully charged, the indicator will be
static and show "full".
• If the battery is not fully charged, the indicator will
scroll from "Battery Empty" to the current battery
capacity for example "Battery ½ Full", to indicate
that the pump is being charged.
When the pump is NOT connected to the mains
power supply, the indicator is static and shows the
approximate charge remaining in the battery.
Battery Empty
Battery ½ Full
Battery Full
If the pump is not connected to the mains power
supply and the battery is fully charged and in
good condition, the pump will continue to operate
normally for approximately 12 hours for calf and
calf and thigh garments, and for approximately 6
hours for foot garments.
The battery has a service life of 5 years
(approximately 600 charge cycles). It is not user
replaceable and must be replaced as part of the
service procedure.
This is a rotating 6-segment circular icon, which
indicates that the pump is initialising after power up.
This shows the total pump run time in hours. Refer to
"Resetting the Patient Run Hours" on page 19 to
clear the patient run hours.
This is the pump run time since the patient run
hours was last reset.
When an alarm which is able to be muted is shown
on the LCD screen, this icon is shown to indicate that
the alarm can now be muted.
9
Battery ¼ Full
Battery ¾ Full