arjo Flowtron ACS900 Notice D'utilisation page 17

Middle Control Button
Left Control Button
Right Control Button
LCD Screen Icons This screen shows the position and description of all
Garment Low Pressure/
Pressure Leak
Indication
Garment Type
and Inflation
Indication
Tubeset
Connector
Number
Audible
Alarm
Muted
Audible Audible Alarm
Alarm Status
When the pump is in Standby and one or two
garments are connected, press this button to put the
pump into the Run mode and start therapy; the LED
indicators on the front and underside of the case will
be illuminated green.
To stop the therapy and put the pump into Standby,
press and hold this button for approximately 2
seconds until the Standby screen is displayed and
then release the button. The LED indicators on the
front case will be extinguished.
If an audible alarm sounds during therapy, press this
button to mute the audible alarm.
Only certain alarms can be muted.
Refer to "Troubleshooting" on page 22 for details
of the various alarm conditions and possible
corrective actions to rectify the faults.
When the pump is in Standby, press this button to
change the alarm volume (refer to "To Change the
Audible Alarm Volume Setting" on page 18).
Press this button to reset the patient run hours. This
can be done either at power up, after the pump has
initialised or if the therapy is stopped and the pump is
in Standby (refer to "Resetting the Patient Run
Hours" on page 19).
possible icons which can be displayed. The actual
icons which will be displayed will depend
on the pump status, patient therapy and whether
a fault has been detected.
Kinked/
Blocked Tube
Start/Stop
Volume Therapy
Mains Power
Not Connected
Wait/ High Temperature
Initialising
7
Mains Power
Connected
Battery Level
Indication
Warning/Alarm
Indication
Hardware Fault/
Service Required
Patient
Run Hours
Alarm