Cleaning Schedule - SOLAC LUCID i10 Mode D'emploi

- To activate the Go Home mode, press the (AJ)
button on the remote control.
WATER TANK ICONTROL MODE
- At the end of the suction process, you can
change the dust deposit through the water
tank (AE) to continue cleaning. The water tank
works by dripping so the mop will moisten and
mop the floor.
- Open the hermetic lid of the tank (AG) and
introduce water into the tank.
- Put the mop that is fastened securely.
- Enter the water tank and select the cleaning
mode you need.
IMPORTANT:
- Do not use the mop outdoors.
- Remove the carpets to avoid damaging them.
- Before loading the robot, remove the water
tank and the mop.

CLEANING SCHEDULE

- The robot vacuum cleaner has cleaning sche-
dule settings that allow you to customize when
you clean your home.
- These settings can only be confirmed via the
remote control.
IMPORTANT:
- Make sure that the remote control is close to
the robot while setting the clock or time.
- Make sure that the power switch is in the ON
position.
1) CONFIGURE THE CLOCK OF THE REMOTE
CONTROL
Press the (AM) button on the remote control, the
time selector starts blinking.
Press the direction buttons
desired time.
Press the direction buttons
minutes or hours.
or to select the
or to select the