Led Indicator - SOLAC LUCID i10 Mode D'emploi

LED INDICATOR

LED LIGHT ROBOT STATUS
Flashing blue Charging
Solid blue Standby / Cleaning /
Fully charged
Solid pink Low power and returning
to Charging Dock
Off Robot is off. To conserve
power, the light auto-
matically turns off when
robot is not docked to
the charging doc and
has been inactive for 1
minute.
Flashing / Solid Robot has an error. Re-
Red + Beeping fer to the troubleshooting
section "Anomalies" in
this manual for solutions
MAINTENANCE
- Disconnect the battery charger from the mains
and allow it to cool before undertaking any
cleaning task.
- Clean the equipment with a damp cloth with a
few drops of washingup liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Do not let water or any other liquid get into the
air vents to avoid damage to the inner parts of
the appliance.
- Never submerge the appliance in water or any
other liquid or place it under running water.
- Never submerge the connector in water or any
other liquid or place it under running water.
LUCID i10 CLEANING
Dust Bin After each
use
Filters Once every
week
Rolling Brush Once every
week
Side Brushes Once every
month
Sensors Once every
month
Charging Once every
Pins month
Swivel wheel Once every
month
EMPTYING THE POWDER TANK:
- Empty the dust container after each use.
- Uncouple the dust container from the applian-
ce.
- Open the emptying lid of the tank where
indicated by the arrows and pour its contents
into an appropriate waste container.
REPLACEMENT
FREQUENCY
-
Every 2 months
Every 6-12
months
Every 3-6
months(or when
visibly worn)
-
-
-