SOLAC LUCID i10 Mode D'emploi page 19

V Sensor base
W Charger
X Load contact points
DUST TANK
Y Dust tank
Z Dust tank cover
AA Textile prefilter
AB EPA Filter
AC Sponge Filter
AD Dust container removal button
WATER TANK
AE Water tank
AF Microfiber mop
AG Hermetic water tank lid
AH Water tank removal button
REMOTE CONTROL
AI AUTO cleaning mode button
AJ Button Cleaning mode Go Home (returns to
the charging station automatically)
AK Direction buttons (up / down / right / left)
AL Start button or stop
AM Button to select the time
AN Button to select the schedule
AO Spiral cleaning mode button
AP Edge Cleaning Mode button
AQ Button Room cleaning mode
AR Maximum suction button in room and AUTO.
NOTA: Insert 2 AAA batteries before using the
remote control for the first time. Make sure that
the positive and negative poles are located in the
correct direction in the battery compartment.
If the model of your appliance does not have the
accessories described above, they can also be
bought separately from the Technical Assistance
Service.
IMPORTANT:
- Cables or other objects on the ground can
hinder the mobility of the robot. Remove these
objects before using the robot vacuum cleaner.
- Use the vacuum cleaner the robot only on short
pile carpets.
- Furniture less than 8cm can block the robot.
Lift the furniture if you need to clean this area.
- Put a safety barrier on the stairs to prevent it
from falling in case the fall arrest sensors do
not work properly.
INSTALLATION
- Be sure to remove all packaging material from
inside the appliance.
CHARGING BASE POSITION:
- Connect the charger to the charging base.
- Place the load base flat and next to the wall.
- To receive a good signal, you must leave a
radius of 1m to the right and left and 2 meters
forward of the base.
- Connect to the power.
INSTALL SIDE BRUSHES:
- Mount the side brushes on the bottom of the
robot by pressing the brushes into its slot.