Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

CLEANING MODES

AUTO CLEANING MODE
- The robot starts to vacuum automatically and
combines the different cleaning modes in one
optimizing the cleaning of your home to the
maximum. To use the AUTO cleaning mode,
press the button (AI) on the remote control.
- When the cleaning cycle ends or if the battery
runs out, it returns to the charging base auto-
matically.
SPIRAL CLEANING MODE
- The robot starts vacuum at a particular point by
spiraling outward approximately (1 meter) in
diameter and then spiraling inward to where it
started. To use the spiral cleaning mode, press
the (AO) button on the remote control.
MAX CLEANING MODE
- The robot increases its suction power to
provide a deeper cleaning.
- To use the MAX cleaning mode, press the (AR)
button on the remote control.
- MAX cleaning mode can only be activated
during operation in AUTO cleaning mode.
EDGE CLEANING MODES
- Once the robot finishes cleaning the open
areas of your floor, use the perimeter mode to
make sure it has been cleaned along the walls
and around the legs of the furniture.
- If you prefer a faster cleaning of the edges,
press the button (AP) on the remote control.
SMALL ROOM CLEANING MODE
- When it is necessary to clean a specific room,
press the room cleaning mode button on the
remote control (AQ).
- When the cleaning is finished, the robot will
stop.
- Make sure to close the doors of the room while
using this mode.
GO HOME MODE
- Mode of return to the charging base automati-
cally when the robot detects that only 15% of
the battery is left.

Publicité

Table des Matières
loading

Table des Matières