ROBBE Power Peak A4 EQ-LCD Notice D'utilisation page 12

3. Controls
LC display (battery voltage, charging current, capacity)
12 V operating
voltage con-
nection
Plug-in
fuse
Regulator for setting the charging current
4. Connection and Start-Up
Ensuring correct polarity, first connect the power
cable to a 12 V car battery or a 12 V DC power
supply unit (red = + terminal, black = - terminal).
The charger is now ready for operation.
Although the charger is polarity reversal-pro-
tected, avoid reversing polarity as this will cause
the fuse to blow.
If polarity has been reversed, the fuse must be
replaced by an identical type (5A) (available from
car accessory outlets or service stations).
The battery is connected directly or via a charg-
ing lead with banana plug to the battery connec-
tion sockets arranged on the right side of the
charger. Ensure correct polarity when connecting
(red = + terminal/black = - terminal).
Although the charger output is protected against
polarity reversal and short-circuits they should,
Table of contents
Power Peak® A4 EQ-LCD
4
nevertheless, be avoided and, if necessary,
immediately rectified.
Connection - delivery specification No. 8560
110-230 V AC
5. Selecting Type of Battery
The corresponding type of battery must be set
after switching on the charger. For this pur-
pose, with the battery not connected, press the
„START" button on the charger, until the required
type of battery is shown in the display.
No.
8559 / 8560
Equalizer
LEDs
Voltage
sensor
connection
Battery
connection
sockets
red = +
black = -
Start button
Status LED
110-230 volts
CA