Mounting And Adjusting The Headrest; Adjusting The Seat Height (Only For 5" Wheels); Mounting The Safety Belt; Mounting The Safety Bracket - Vermeiren Pluo Manuel D'utilisation

5.3

Mounting and adjusting the headrest

1. Loosen the two screws (25) on the headrest support.
2. Clasp the headrest to the backrest frame (26).
3. Firmly tighten the two screws (25). Make sure that the
headrest is well secured.
4. Loosen the knob (27) by hand to adjust the headrest height
up/down to the desired position. Retighten the knob firmly.
5.4

Adjusting the seat height (only for 5" wheels)

The seat height can be adjusted over a distance of 90
mm (in steps of 30 mm).
1. Remove the screw (28) from the leg.
2. Adjust the leg to the desired height by sliding
the inner tube (29) up/down in the outer
frame tube (30).
3. Replace the screw (28) and firmly tighten.
4. Repeat for the other legs. Make sure that all
legs are firmly secured, and that they have been set to the same height.
5.5

Mounting the safety belt

The safety belt is attached to the frame by the two lower screws
(31) of the backrest.
5.6

Mounting the safety bracket

To mount the safety bracket, slide it sideways on the armrests from one side to the other.
30
29
9
Pluo
2019-10
25
26
27
28
31
EN
NL