STERWINS 500 CDW-3 Notice De Montage, Utilisation Et Entretien page 177

Pompe d'evacuation 2 en 1

Les langues disponibles

Operate the product : illustration 4.1 to 4.5

It is recommended to use a rope attached to the handle to install the pump at the bottom of the water.

CAUTION ! Do not use the power cord nor the float switch to lift

the pump.

Make sure that the pump is installed upright and stable on the bottom of the water.

Then make sure that the float switch is raising in upper position. Pump needs at least 40 cm of water to

start automatically.

Plug in the electrical outlet.

Note : The pump will start automatically after plugging the

cable outlet.

• Operate the product only at reasonable hours – not early in the

morning or late at night when people might be disturbed.

• Do not modify the product in any way or use parts and

accessories that are not recommended by the manufacturer.

If the product is dropped, suffers heavy impact or begins to

vibrate abnormally, immediately stop the product and

inspect for damage or identify the cause of the vibration. Any

damage should be properly repaired or replace by an

authorized service center.

Stop the pump

Once the water is drained, the floater moves to the low position and the pump stops by itself.

• You shall never block the floater manually

• To reduce the risk of injury, always stop the machine :

- before cleaning or clearing a blockage

- when leaving the product unattended

- before installing or removing attachments

- before checking, maintaining or working on the product

- if the machine starts to vibrate abnormally (inspect

immediately)

4.5 SPECIFIC FUNCTIONS

There is no specific function about this product.

177