weinor BiSens SWR-230V Instructions De Montage page 9

Installation instructions (translation)
wind sensor
Underside of the device
DOWN
button
STOP
- / P button
/ P
alarm-LED
wind
sensor
UP button
The BiSens SWR-230V is a sun/twilight and wind sensor for
sun protection systems.
The BiSens SWR-Solar additionally has a rain sensor.
Signal transmission between the BiSens SWR-Solar and the
receiver is via a radio link.
Note
The device will only work in connection with compatible
radio receivers from the range of the weinor BiConnect radio
system.
Manual operation of the system is carried out with a hand-
held/wall transmitter. This item is not included in the scope of
delivery.
All manuals and user guides at all-guides.com
light sensor rain sensor
light sensor
wind sensor
wind potentiometer
rain potentiometer
light
LED
operating-LED
light potentiometer
twilight potentiometer
BiSens SWR-230V
Safety instructions
The instructions must be observed in order to
ensure the product can be operated smoothly
and safely and its properties can be fully
realised.
• The operator/user must have completely read and
understood the instructions.
• The operator must ensure that the operating instructions are
made available to the user in a legible form.
• The operator must ensure that all safety measures are
observed and met.
• The following safety and assembly instructions apply to the
device and not to the accessories and drive.
Failure to observe these can cause physical injury!
 Observe all safety instructions!
• Never install or take into operation devices which are
damaged.
• Only use unmodifi ed and compatible original parts.
• If the device is opened without permission or used in an
improper manner, or if it is incorrectly installed or operated,
there is a risk of damage to persons and property.
• The device contains small parts which can be swallowed.
Transport
• Should you receive the device in a damaged condition
despite proper packaging, you must not put it into operation.
Complain about the damage to the transport company
immediately.
Installation
• Observe the regulations during installation.
• The device may only be used by persons who have read
and understood the instructions.
Operation
• If transmitters are used for controlling the system, its
operating range must stay visible during operation.
• Keep control systems out of the reach of children and the
disabled.
Safety instructions for radio operation
Observe all safety instructions for radio
operation!
Only use radio systems which are approved and can be
operated without interference.
• The radio systems must not be operated in areas where
there is a heightened risk of interference (e.g. hospitals,
airports).
• The remote control is only approved for devices and
systems for which any malfunction of the transmitter or
receiver would not result in a risk for persons, animals
or property, or if such a risk is covered by other safety
equipment.
181229006_EN_1113