Publicité
Les langues disponibles
Les langues disponibles
Make the Electric
Connections
WARNING: To avoid possible electrical shock,
be sure electricity is turned off at the main fuse box
before wiring.
Step 1. (Fig. 8) Insert the receiver into the
mounting bracket with the flat side of the receiver
facing the ceiling.
Step 2. (Fig. 9) Motor to Receiver Electrical
Connections: Connect the Red wire from the fan
to Red wire from the receiver. Connect the
Yellow wire from the fan to the Yellow wire
from the receiver. Connect the Gray wire from
the fan to the Gray wire from the receiver.
Connect the Blue wire from the fan to the Blue
wire marked "For Light" from the receiver.
Connect the White wire from the fan to the White
wire marked "For Light" from the receiver.
Secure wire connections with the plastic wire
nuts provided.
5.
Step 3. (Fig. 9) Receiver to House Supply Wires
Electrical Connections: Connect the black (hot)
wire from the ceiling to the black wire marked
"AC in L" from the receiver. Connect the white
(neutral) wire from the ceiling to the white wire
marked "AC in N" from the Receiver. Secure the
wire connections with the plastic wire nuts
provided.
Step 4. (Fig. 9) If your outlet box has a ground
wire (green or bare copper) connect it to the
receiver main ground wire,connect the receiver
other ground wires and hanging ball ground
wire together. Otherwise connect the mounting
bracket ground wire to the receiver main
ground wire,connect the receiver other ground
wires and hanging ball ground wire togeth-
er.Secure the wire connection with a plastic nut
provided. After connecting the wires spread
them apart so that the green and white wires are
on one side of the outlet box and black wires is
on the other side. Carefully tuck the wire
connections up into the outlet box.
NOTE: Fan must be installed at a maximum
distance of 20 feet or less from the transmitting
unit for proper signal transmission between the
transmitting unit and the fan's receiving unit.
NOTE: Convert your fan to WIFI by
adding a P2673-01 WIFI Module.
Receiver
Mounting
bracket
Outlet box
White (neutral)
Black (hot)
Green or bare
copper (ground)
Main ground
(green)
Ground (green)
Black ("AC IN L")
White ("AC IN N")
Receiver
Red
Blue ("For Light")
Yellow
White ("For Light")
Gray
Red
Ground
Yellow
(green)
Gray
Blue ("For Light")
White ("For Light")
Figure 8
Figure 9
Publicité
