Publicité
Les langues disponibles
Les langues disponibles
INSTALLING THE
BATTERY
Remove the back cover on the transmitter and
install a 12V battery that is included with the
remote control. (Fig. 17)
LEARNING PROCESS
NOTE: After the AC power is on, do not press
any other button on the remote control before
pressing the
button. Doing so will cause the
procedure to fail.
Should you desire to use another remote control
unit with your new fan, install one using the
steps below:
Within 30 seconds of turning the fan's AC power
ON, press and hold the
button for 5 seconds
to enter the learning function. Once the receiver
has detected the set frequency, the down light of
your fan, if applicable, will blink twice. There is
no indication if your fan is not equipped with a
light.
9. Operating Your Transmitter
Figure 17
INSTALLING THE
TRANSMITTER HOLDER
Attach the remote control holder with the two
remote control holder mounting screws.(Fig.18)
Figure 18
Publicité
