GRAU XT-A Mode D'emploi page 13

STATUS ENQUIRY (ENQUIRY MODE)
The status of settings can be queried by means of the remote control. By executing the following key
combinations you will NOT be brought into the programming mode.
The indicator LED at the sensor will light up either green or red.
MODE 1
LED red: MODE 1 OFF - Individual office space is active
LED green: MODE 1 ON - Open plan office mode is active
MODE 2
LED green: MODE 2 ON - Movement sensor is active
LED red: MODE 2 OFF - Movement sensor is inactive
MODE 3
LED green: MODE 3 ON - Constant light regulator is active
LED red: MODE 3 OFF - Constant light regulator is inactive
MODE 4
LED green: MODE 4 ON - Auto ON is active
LED red: MODE 4 OFF - Auto OFF is active
MODE 5
LED green: MODE 5 ON - Saved light value with switch Z is possible
LED red: MODE 5 OFF - Saved light value is not possible
MODE 6 only with installed LIGHTDIM CONNECT
LED red: MODE 6 OFF - Swarmfunction inactive
LED green: MODE 6 ON - Swarm function active
Scene Change
When the luminaire is turned on, both the direct and indirect components will produce light. This is our
recommended light distribution that guarantees both a sufficient luminance below the luminaire, as well as
in the area around it.
However, you can change the light output to only direct or indirect with the button
This conversion takes place only temporarily, i.e. when the light is turned off, the setting is reset. The next
time the luminaire is switched on, both lighting components will be activated.
6
Key Combination
1
2
3
4
5
6
.