GRAU XT-A Mode D'emploi page 10

Functions Description for Remote Control
The remote control is not essential for the operation of the luminaire!
The remote control is primarily used to adjust the factory/standard settings made by us, or to link the ligh-
ting together with built lightdim connect (swarm function). Also, the remote control can be used to carry out
status inquiries to determine which modes are set at the time (see Status check).
The remote control is supplied with the luminaire, but is not limited to that specific luminaire so that you can
operate the other sensor equipped Tobias Grau luminaires with your remote control.
Furthermore, with the remote control luminaires can be switched on / off, dimmed, or (as long as the lumi-
naire is switched on) temporarily change the light distribution of the luminaire (see scene change).
Programming
The individual programming steps are described below.
The remote control should be pointed towards the sensor when pressing the buttons.
There is not set time limit for entering combinations, allowing you enough time to enter the key combination
without rushing.
Should you press the wrong button by mistake, you can stop the process by pressing the
tively you can also turn the luminaire off and begin the command again.
NOTE: After entering the key combination
This indicates that you are in the programming mode. With the
mode at any time.
Mode description and instructions for changing the mode
Factory settings of the sensor
The luminaire is supplied with the
following mode settings:
0000 the LED at the Senor will begin to flash orange.
Mode 1 OFF
Mode 2 ON
Mode 3 ON
Mode 4 ON
Mode 5 OFF
Mode 6 OFF
After-glow period 15 mins
3
button you can exit the programming
button; alterna-