Continental Fireplaces Constructeur 36 Serie Manuel D'installation Et D'opération page 54

NOTE: ENSURE NOMENCLATURE IS
2 2
CONSISTENT THROUGHOUT.
finishing
EN
IF SPACE IS LEFT OVER, USE THIS BOX TO
SHOW CORRECT FINAL LOG
PLACEMENT WITH PHOTOS.
IF NOT, USE BOXES AS ABOVE.
note:
When burning, a good indicator that logs are installed correctly is that each flame stands reasonably straight. If a
log splits a flame or drastically changes the direction of a flame, review instructions again and/or pivot log out of
direct contact.
9.7 glowing embers
IF APPLICABLE, USE THIS BOX TO SHOW
"NATURAL GAS ONLY" LOG PLACEMENT.
WARNING
!
• Completely blocking the burner ports can cause an incorrect fl ame pattern, carbon deposits and delayed
ignition.
Tear the embers into pieces and loosely layer above the burner ports covering the burner area. Care should be
Natural Gas Models Only:
taken to shred the embers into thin, small irregular pieces as only the exposed edges of the fi bre hairs will glow.
PLACE TEXT BOX HERE.
The ember material will only glow when exposed to direct fl ame; however, care should be taken to not
NOTE: ENSURE NOMENCLATURE IS
block off the burner ports.
CONSISTENT THROUGHOUT.
Blocked burner ports can cause an incorrect fl ame pattern, carbon deposits and delayed ignition. PHAZER™
logs glow when exposed to direct fl ame. Use only certifi ed "glowing embers" and PHAZER™ logs available from
your local authorized dealer / distributor.
9.8 charcoal embers
WARNING
!
• Do not block or close off the burner ports. Blocked ports can cause an incorrect fl ame pattern, carbon
deposits and delayed ignition.
• When supplied, charcoal embers, charcoal lumps and vermiculite are not to be placed on the burner.
Randomly place the charcoal embers along the front and sides of the log support in a realistic manner.
Fine dust found in the bottom of the bag should not be used.
note:
Charcoal embers are not to be placed on the burner.
9.9 logo placement
Remove the backing of the logo supplied and place, as illustrated.
54
W415-3094 / B / 05.09.22
3 3
D1 D1
NOTE: ENSURE NOMENCLATURE IS
2 2
6 6
CONSISTENT THROUGHOUT.
IF SPACE IS LEFT OVER, USE THIS BOX TO
SHOW CORRECT FINAL LOG PLACEMENT
WITH LINE DRAWINGS.
IF NOT, USE BOXES AS ABOVE.
IF APPLICABLE, USE THIS BOX TO SHOW
"PROPANE ONLY" LOG PLACEMENT.
Propane Models Only:
PLACE TEXT BOX HERE.
NOTE: ENSURE NOMENCLATURE IS
CONSISTENT THROUGHOUT.
22.2
1/2"(12.7mm)
45.5
5 5
48.3
22.1A
INSERT
LOGO
IMAGE
1/2"(12.7mm)
HERE