Continental Fireplaces Constructeur 36 Serie Manuel D'installation Et D'opération page 52

Log Number
finishing
EN
1
9.6 log placement
2
WARNING
!
3
4
• Failure to position the logs in accordance with these diagrams or failure to use only logs specifi cally approved
with this appliance may result in property damage or personal injury.
5
• Logs must be placed in their exact location in the appliance. Do not modify the proper log positions, since
6
appliance may not function properly and delayed ignition may occur.
• The logs are fragile and should be handled with care.
7
8
PHAZER™ logs and glowing embers, exclusive to Continental, provide a unique and realistic glowing effect that
is different in every installation. Take the time to carefully position the glowing embers for a maximum glowing ef-
"PHAZER™ logs [and glowing embers], exclusive to Napoleon/Continental, provide a unique and realistic
9
fect. Log colours may vary. During the initial use of the appliance, the colours will become more uniform as colour
glowing effect that is different in every installation. Take the time to carefully position the glowing embers for a
10
pigments burn in during the heat-activated curing process.
maximum glowing effect. Log colours may vary. During the initial use of the appliance, the colours will become
more uniform as colour pigments burn in during the heat-activated curing process."
Insert only if
applicable ---->
Log Number
1
2
Studs
3
(Log #2)
4
5
6
IF APPLICABLE, INSERT DRAWING OF BURNER/SUPPORT WITH APPROPRIATE LA-
7
8
IF NOT APPLICABLE, HIDE THIS SECTION AND USE BOXES BELOW.
9
10
IF APPLICABLE, INSERT DRAWING OF BURNER/SUPPORT WITH APPROPRIATE LA-
IF NOT APPLICABLE, HIDE THIS SECTION AND USE BOXES BELOW.
52
W415-3094 / B / 05.09.22
Part Number
If applicable, insert the following statement:
note:
Log numbers are located on the bottom or back of the logs.
Part Number
Burner
Ports
BELS (I.E. STUDS, PILOT SHIELD, BURNER PORTS, ETC.).
B2
B1
Media
Tray
Holes under log
(not illustrated).
Burner Overview
1
Notch
BELS (I.E. STUDS, PILOT SHIELD, BURNER PORTS, ETC.).
A1
A2
Holes under log
Pilot Shield
Stud
(Log #1)
A1
C2
C1
Media
Tray Edge
2
B2
B1
Description
Description
Stud
(Log #1)
Studs
(Log #3)
A2
D1
Stud
(Log #5)
Holes under log
(not illustrated).
1
Holes and notch