Dal Zotto Inserto 700 Air Manuel Utilisateur page 54

FRONT PELLET LOADING KIT
The optional pellet loading kit allows to load the pellets into the
hopper from the front without having to remove the insert (which
would require the machine to be switched o ).
DO NOT LOAD A GREATER NUMBER OF PELLETS THAN THE CAPACITY OF THE HOPPER AND DO NOT DROP PELLETS
INSIDE THE PRODUCT.
IN CASE OF INSTALLATION WITH LOADING KIT OPTIONAL THE MACHINE MUST NOT BE REMOVED.
Further information on accessories is available on the website under the category "accessories".
BULB THERMOSTAT REARM
The gure below shows the hopper rearm position. It is
recommended to contact the quali ed technician if one of the
rearms should be triggered, so as to verify the cause.
54
OPTIONAL LOADING ACCESSORIES
UPPER/SIDE PELLET LOADING KIT
The optional pellet loading kit allows to load the pellets into the
hopper without removing the insert from the installation opening
(which would require the machine to be switched o ).
The kit can be assembled at a later time too.
FUSE
If the stove has no power supply, check the status of the fuse,
positioned laterally, located on the circuit board support.
ENGLISH