Dal Zotto Inserto 700 Air Manuel Utilisateur page 53

EXTRACTION OF INSERT AND PELLET LOADING
Extraction of the insert allows both the pellets to be loaded inside the hopper and routine maintenance (cleaning the ash pipe at year end) or
unscheduled maintenance (replacement of mechanical parts if the product should break) to be performed.
To extract the insert, follow the procedure below:
Open the re door and turn the latch clockwise (using the poker supplied).
Turn the stove towards you using the pokers supplied until it blocks automatically.
THE INSERT MUST ONLY BE PULLED OUT WHEN THE STOVE IS SWITCHED OFF AND COMPLETELY COLD!
PELLETS AND FEEDING
Pellets are made by subjecting wood shavings i.e. the rejects of pure wood (without paint) sawmill, carpenter products and products from
other activities connected to working and transforming wood, to very high pressures.
This type of fuel is fully ecological as no glues are used to hold it together. Indeed, the pellets remain compact over time due to a natural
substance found in wood: lignin.
As well as being an ecological fuel, as wood residues are made the most of, the pellet also has technical advantages.
While wood has a calori c value of 4.4 kWh/kg. (with 15% humidity, thus after 18 months of seasoning), the calori c value of the pellet is 5
kWh/kg.
Pellet density is about 650 kg/m3 and water content is equal to 8% of its weight. For this reason, the pellets do not need to be seasoned in
order to obtain a su ciently adequate heat yield.
The pellet used must comply with the features described by Standards:
EN PLUS class A1, ISO 17225-2 class A1
and
UNI EN 303-5 with the following characteristics: Water content ≤ 12%, ash content ≤ 0.5% and heating value less than >17 MJ/kg (for boilers).
The manufacturer recommends using pellets with a diameter of 6 mm with its products.
PELLET STORAGE
To guarantee combustion without problems, the pellets must be kept in a dry place.
Open the hopper lid and load the pellets using a scoop.
DO NOT PLACE THE BAG DIRECTLY ON THE STOVE WHEN LOADING THE HOPPER!
ALWAYS USE A SCOOP TO LOAD THE HOPPER.
THE USE OF POOR QUALITY PELLETS OR ANY OTHER MATERIAL DAMAGES THE FUNCTIONS OF YOUR STOVE AND CAN
VOID THE WARRANTY AND THE RELEVANT RESPONSIBILITY OF THE MANUFACTURER.
TO GUARANTEE COMBUSTION WITHOUT PROBLEMS, THE PELLETS MUST BE KEPT IN A DRY PLACE.
THE SURFACES MAY BE VERY HOT! ALWAYS USE SAFETY GLOVES!
ENGLISH 53