2.2 Product description
120 g
123 x 66 x 16 mm
22
2.3 Activation
NOTE!
Note! In order to proceed with activation you will
need the device ID. Please write this number down
before installing your FINDER.
In order to start using your VEHICLE Finder 1.0, first you will
have to activate it online. Please enter the following link:
www.start.finder-portal.com
...or simply scan the shown QR code
and follow the instructions.
2.4 Start up
The moment you successfully activate your device; you can start your
FINDER. Please observe the following points before connecting
the device to the vehicle battery:
SIM card is already in the VEHICLE Finder 1.0
The VEHICLE Finder 1.0 should not be attached to fuel lines
or other combustible components.
No other components of your vehicle should be damaged by the
attachment.
When installing the VEHICLE Finder 1.0 and therefore connec-
ting it to your vehicle's battery, beware that in order to supply
your device with sufficient power, your vehicle's battery may
discharge. If the battery is intact and you are regularly on the
road, this should not happen as your vehicle's battery will be re-
charged constantly while driving. If this were not the case, check
whether your battery is equipped with protection against battery
discharge before connecting your VEHICLE Finder 1.0 and retro-
fit it if necessary. In standby mode, the Finder will need from 10
to 20 mAh approximately.
Please always observe the manufacturer's specifica-
tions for your vehicle. Compensation claims due to
incorrect connections are hereby excluded.
23