Publicité
Les langues disponibles
Les langues disponibles
Assembly
Assembling Engine and Drive
Shaft Assembly
The drive shaft, clutch drum housing and gearcase are
assembled. Attach the clutch drum housing to the
engine using the four M5 x 20 screws supplied with the
unit.
Engine
Loop Handle Installation
The loop handle kit contains a package of four screws
nuts and the bottom clamp for the loop handle.
Screw (4)
Nut (4)
M5 x 20 Screw (4)
Shaft
Clutch Drum Housing
Loop Handle
Rubber Sleeve
Bottom Clamp
— US-12 —
1.
Place the loop handle and the bottom clamp
approximately 9 inches (22.8 cm) from the end of
the stop switch/throttle trigger assembly for an
initial handle position.
2.
Install the four screws and nuts. Leave the screws
finger-tight.
3.
Reposition the loop handle up or down the drive
shaft to the most comfortable position, but no
closer than 9 inches (22.8 cm) from the end of the
stop switch.
4.
Tighten the screws and nuts.
Publicité
