IKEA FINSMAKARE Mode D'emploi page 11

ENGLISH
Step 4 Turn on the oven and set the function: True Fan + Steam. Set the temperature to
230 °C. Turn off the oven after 25 min and wait until it is cold.
Step 5 Turn on the oven and set the function: True Fan + Steam. Set the temperature
between 130 and 230 °C. Turn off the oven after 10 minutes and wait until it is
cold.
To prevent limestone residue empty the water tank after each steam cooking.
Turn off the oven.
The table below shows water hardness range (dH) with the corresponding level of calcium
deposit and the quality of water. When water hardness exceeds level 4, fill the water drawer
with bottled water.
Water hardness
Level dH
1 0 - 7
2 8 - 14
3 15 - 21
4 22 - 28
How to remove and install: Door
The oven door has four glass panels. You can remove the oven door and the internal glass
panels to clean them. Read the whole "Removing and installing door" instruction before you
remove the glass panels.
Caution! Do not use the oven without the glass panels.
When the cleaning ends:
Empty the water
tank. Refer to Daily
use, "Emptying the
water tank" chapter.
Test strip
To download the full version visit www.ikea.com
Rinse the water tank and
clean the remaining lime‐
stone residue with a soft
cloth.
Calcium deposit Water classifi‐
(mg/l)
0 - 50 soft
51 - 100 moderately
hard
101 - 150 hard
over 151 very hard
Clean the drain pipe
with warm water
and a mild deter‐
gent.
Clean the wa‐
cation ter tank every
75 cycles - 2.5
months
50 cycles - 2
months
40 cycles - 1.5
months
30 cycles - 1
month
11