IPC 121298 Manuel D'utilisation Original page 42

8. Troubleshooting
WARNING
Risk of cutting due to broken glass, metal
or other sharp edged materials!
When emptying the sweeping container,
cutting injuries may occur due to broken glass,
metal or other sharp edged materials.
• Wear the prescribed personal protective
equipment!
CAUTION
Health impairments caused by dust
resulting from sweeping!
The inhalation of dusts can endanger the
health.
• Wear the prescribed personal protective
equipment!
CAUTION
Risk of injury through tipping over of the
telescopic bracket!
Tipping over of the telescopic bracket may
lead to slight injuries, such as jamming of
the finger or haematomas in users or other
persons.
• When carrying the device, hold it so that the
telescopic bracket cannot tip over.
Even if the prescribed maintenance work and
checks of the device before use are complied
with, faults may occur. Possible faults are listed
in the table below, with specification of the cause
and remedy.
8.1 Fault table
Fault Cause
Device is
contaminated
Broom blocked
Contaminated
Device is broom drives
running with
Height
difficulty or
adjustment
roughly
is set too
low, contact
pressure of the
plate brooms
too high
Plate brooms do
not rotate
Bristles are Improper
bent storage
Sweeping Sweeping lip is
result is missing, loose
insufficient or worn
Troubleshooting
Remedy
Clean device, see
Section
Remove blockage see
Section "Remove
blockage"
Clean broom drives, see
Section "Clean device"
Set height adjustment,
see Section in the
section "Adjust height
setting"
Contact Service
Align the bristles, see
Section in the section
"Align bristles"
Replace sweeping lip
EN
39