Alecto WS-2300 Mode D'emploi page 16

Expansion:
You can register up to 3 outdoor units to the indoor unit to have the
temperature measured at 3 different locations (e.g. in your green-
house, pet room, different bedrooms, etc.). You can order additional
outdoor units via the internet at www.alecto.nl
Registering additional outdoor units:
1. slide down the battery cover at the rear of the new outdoor unit
and insert 2 AA 1.5V batteries according to the markings inside
the battery compartment.
2. just above the batteries at the rear of the outdoor unit, slide the
'CH' channel switch to position 2 or position 3.
3. slide the battery cover back onto the outdoor unit.
4. now repeatedly and briefly press the CH at the rear of the indoor
unit until
selected 'CH-2' or 'CH-3' in the outdoor unit) and then briefly press
the SENSOR button.
5. the indoor unit will now start searching for the outdoor unit and as
soon as the units find each other, the temperature will be shown
on the display of the indoor unit.
Reset/System error:
If the WS-2300 shows a possible error, you may have to reset the
indoor and outdoor unit.
1. use a sharp object to press the reset button at the rear of the
indoor unit.
2. use a sharp object to press the reset button at the rear of the
outdoor unit (for this, you'll need to briefly remove the battery
cover from the outdoor unit).
The indoor and outdoor units will then be reset and a new pairing
scan will start. After several seconds, you can continue using the
WS-2300.
If you still have no connection or sound, please contact the customer
service of Alecto via internet www.alecto.nl
or illuminates (depending on whether you've
16