Alecto WS-2300 Mode D'emploi page 14

Switching the DCF receiver on/off:
You can turn off the DCF receiver as follows, allowing you to have
only the time and date shown on the display according to your pro-
gramming:
• turn off: press and hold the RCC button at the rear of the indoor
unit for 4 seconds until the
You can turn the receiver back on as follows:
turn on: briefly press the RCC button at the rear of the indoor unit
•
until the
'DST' in the display.
'DST' stands for Daylight Saving Time.
'DST' illuminates when the displayed time is the daylight saving time.
Alarm:
Setting & turning on the wake-up alarm:
1. press and hold the ALARM SET button for
2 seconds
2. use +/‑ to set the hours and briefly press the ALARM SET button
3. use +/‑ to set the minutes and briefly press the ALARM SET
button, the alarm time is now saved (and is also activated imme-
diately)
Switching on/off:
Briefly press 2x the ALARM SET button. When the wake-up alarm
is currently enabled, " " will be shown; if " " is not illuminated, the
alarm is disabled.
Operation:
• As soon as the set time is reached, the alarm will sound for up to
120 seconds.
• Press the ALARM SET button to stop the alarm signal earlier or
press the SNOOZE/ LIGHT button to enable the snooze function;
the wake-up alarm will then sound again after 5 minutes.
• The alarm is repeated daily.
Temperature display:
Use the °C / °F switch at the rear of the indoor unit to display the
temperature in degrees Celsius or in degrees Fahrenheit.
antenna symbol starts flashing
antenna symbol disappears.
14