Bosch Indego XS 300 Notice Originale page 29

Problem Possible Cause
Rough mowing conditions
Grass too long
Slopes in garden too steep
Mower gets stuck in Objects/obstacles not marked out
garden
Newly laid turf
Mower unintentionally Objects/obstacles below 5 cm not marked
cuts flowers, etc. or out
runs over certain
obstacles
Mower does not ap- LogiCut system depends on the garden
pear to cut logically conditions. Mower does not necessarily
have to continue in the next uncut area.
Mower does not always go in a straight line
when travelling between areas
Mower frequently does not find right posi-
tion or turns on the spot
Wire crossed while marking an object
Mower runs in random paths in an addi-
tional lawn without docking station.
Perimeter wire keeps Wire is not taut between pegs
being cut
Distance between pegs is more than 75 cm
Mower leaves ragged The mower does not mow often enough
finish/poor quality of
cut
Cutting blades blunt
Possible clogging
Perimeter wire not No power at the docking station
detected
Perimeter wire damaged/cut
Wrong installation (e.g. not enough dis-
tance between wires)
Perimeter wire close to a source of interfer-
ence
Bosch Power Tools
Corrective Measure
Select "uneven ground/low sensitivity" option from menu
item "lawn condition/bump sensor".
Flatten garden/remove/bumps/mark out unsuitable
areas with the perimeter wire – Please follow the instruc-
tions in the Installation Guide.
Select "uneven ground/low sensitivity" option from menu
item "lawn condition/bump sensor".
Ensure mower only operates on slopes of 15 degrees or
less and full garden is not on a slope.
Use the perimeter wire to mark off obstacles where the
mower often gets stuck.
Allow a few weeks for the soil to settle before using the
mower.
Change setting in menu item "lawn condition / bump
sensor" to low sensitivity / uneven.
After watering, wait as long as possible until you start the
mower.
Mark obstacle using perimeter wire leaving 30 cm from
object or remove objects/obstacles.
Further information can be found on the Installation
Guide.
If behaviour re-occurs often, remap lawn area.
No corrective action needed.
Change wire ID.
Follow instructions in the Installation Guide.
Normal behaviour. The LogiCut system only works in
areas with docking station.
Make wire taut and ensure distance between pegs is
maximum 75 cm. Use the wire connectors to repair the
cut. Avoid using a verticutter, scarifier, etc. over the peri-
meter wire.
Mow more frequently for a good result (e.g. by means of
more/longer slots in schedule).
Reverse or replace cutting blades (see figure J).
Always turn isolator switch off first, then check under-
neath the mower. Clear out as necessary (always wear
protective gloves).
Check if the docking station is powered up (LED is on).
Check perimeter wire for damage.
Follow instructions in the Installation Guide.
Remove any excess (e.g. coiled up) perimeter wire
around the docking station. Change perimeter wire ID in
the menu.
F 016 L94 037 | (11.11.2020)
English | 29