Bosch Indego XS 300 Notice Originale page 28

28 | English
Problem Possible Cause
The LED on the dock- The perimeter wire is cutt, too long or too
ing station flashes short. Wire not connected and mower not
in the docking station.
Excessive vibrations/ Blade bolt loose
noise
Cutting blade damaged/bent
Mower not docking Perimeter wire not properly layed out
reliably around docking station
Perimeter wire close to a source of interfer-
ence
Mower fails to operate Isolator switch not turned on
Possible clogging
Battery not fully charged
Grass too long
Battery too hot/cold
Mower standing on Operational problems
lawn with the display
switched off
Mower does not Battery too hot/cold
charge
Docking station not switched on
Charging pins corroded
Mower out of peri- Perimeter wire on a slope
meter wire
Obstacle near perimeter wire
Parts of the lawn area Mower requires more cuts to finish garden Allow mower to run for 3 full cuts to cover whole lawn
left uncut
Time slot not long enough for garden size
Distance between perimeter wires too
small
F 016 L94 037 | (11.11.2020)
Corrective Measure
Check that the perimeter wire is not interrupted and is
between 20 and 250 meters in length. Then switch
power supply off and then on again.
Follow instructions in Installation Guide to install the
mower.
Tighten blade bolt to torque of 2.5 Nm.
Replace cutting blade (see figure J).
Follow instructions in Installation Guide on layout of peri-
meter wire.
Remove any excess (e.g. coiled up) perimeter wire
around the docking station.
Change perimeter wire ID in the menu.
Remove mower out of docking station, turn isolator
switch on and place mower back into docking station (en-
sure docking station is on – LED lights up green).
Always turn isolator switch off first, then check under-
neath the mower. Clear out as necessary (always wear
protective gloves).
Place mower in the docking station to allow to charge.
Docking station must be on.
Mow lawn with conventional lawnmower to its lowest
height-of-cut setting before using the mower.
The mower operates when the battery internal battery
temperature is between 5 °C – 45 °C. Allow mower to
cool down/warm up. If the error occurs frequently, the
docking station should be positioned in the shade.
Press confirm button for screen to light up, or place
mower in docking station.
The mower operates when the battery internal temperat-
ure is between 5 °C – 45 °C. Allow mower to cool down/
warm up. If the error occurs frequently, the docking sta-
tion should be positioned in the shade.
Switch on power supply to docking station. If docking
station does not start, contact your Bosch Service
Centre.
Clean the charging pins.
Leave 30 cm between the perimeter wire and the slope.
Remove obstacle.
area.
Increase mowing time slot or use "Bosch AUTO" calen-
dar function.
Increase distance between the perimeter wires to a min-
imum of 75 cm.
Bosch Power Tools