Stabila Laser LAR-250 Mode D'emploi page 16

Operating status display and error messages
The red LEDs (5a) next to the corresponding buttons show the operating mode
selected.
Illuminated green LED
Illuminated green LED +
laser beam flashing
Flashing green LED
+ laser beam flashing
Illuminated red LED
Illuminated red LED
+ laser beam flashing
Flashing red LED
+ laser beam flashing
The red + green
LEDs flash
+ the laser beam
cannot be seen
NB:
This is a class IIIa laser.
Do not look directly into the laser beam !
Keep this product away from children !
The available laser goggles are not safety
goggles. They are designed to make the laser
light easier to see.
The use of operating and adjustment equipment
other than that indicated here or the use of other
procedures can lead to dangerous exposure to
radiation.
Find Quality Products Online at:
-> laser in operation
-> The laser levels itself automatically
-> The unit is inclined too much
+ is outside the self-leveling range
+ the laser cannot level itself automatically
-> laser in operation
-> battery voltage very low
-> battery replacement required imminently
-> The laser levels itself automatically
-> Battery voltage very low
-> Battery replacement required imminently
-> Battery voltage very low
-> The unit is inclined too much
+ is outside the self-leveling range
+ the laser cannot level itself automatically
-> The temperature in the unit is over 122°F / 50°C
-> The laser diodes have been switched off to protect
against overheating
-> Place the unit in the shade to be able to continue
working.
-> The laser is not working
GlobalTestSupply
www.
12
via the LEDs
.com
sales@GlobalTestSupply.com