Stabila Laser LAR-250 Mode D'emploi page 10

After switching on (via button 3), press button (4c) until the Z LED lights.
The unit is now in height of tool alert function mode.
3
Buttons (17) and (18) on the remote control can now be used to incline this laser
plane at right angles to the line from the targeting marks. The inclined plane is
automatically leveled horizontally in this line's direction.
4c
(17)
(18)
Marking out vertical areas
B
Set the rotation laser on its side feet for vertical leveling (10). Align the unit
manually so that the direction of the vertical laser plane described by the lens is
approximately parallel or at right angles to a reference line (e.g. a wall or a corner).
3
Press button (3) briefly to switch the unit on. It is now in Height of Tool Alert
function mode.
You can use the remote control to set the rotation speed (17, 18) or to switch
17
over between point and line function (16). The vertical laser plane described
by the rotating deflected laser beam can only be adjusted in Point mode,
by ± 5°, using buttons (17) and (18). In this way, the laser plane can be
18
aligned precisely parallel or at right angles to the reference line.
16
Use as a Plumb-line Laser
E
The laser can be aligned precisely on a marked cross using the 4 markings (15)
on the base to transfer a plumbline from the floor marking to the ceiling. The
point where the cross intersects corresponds to the SP1 vertical laser emitter.
A correct result can only be obtained in Automatic mode with the unit set on a
level surface!
Find Quality Products Online at:
-> The laser plane tilts
-> The laser plane tilts in the opposite
direction
GlobalTestSupply
www.
(vertical leveling)
6
.com
sales@GlobalTestSupply.com