Remote Control - Stabila Laser LAR-250 Mode D'emploi

Adjustment - Vertical
If a tolerance has been exceeded when performing the vertical check, the laser
can be re-adjusted as follows. Switch the laser off. To go to Adjustment mode,
hold down button (4a) first. Additionally press button (3).
As soon as the y LED illuminates, release button (4a).
The Z LED now flashes rapidly.
The laser can now be adjusted in the Z-axis.
The laser is correctly adjusted when the laser dot is precisely centered between
Points 1 and 3 for the vertical check. Adjust the dot's height using buttons (17)
and (18) on the remote control until it is precisely between Points 1 and 3.
Full batteries must be used when using the adjustment function!
Saving the adjustment
The laser is now adjusted again. Pressing button (14) on the remote control saves
the settings. If you do not wish to save the setting, exit Adjustment mode without
saving by pressing the button (3) on the laser. The old setting is then kept
unchanged.
Replacing the
batteries
Rotation laser
Unfasten the catch on
the battery compartment
cover: remove the cover
and the batteries. Insert
new batteries following
the instructions in the
battery compartment.
Only use 1.5V mono cells
(size D)!
Suitable batteries
can also be used.
Tip:
Remove the batteries if the unit
will not be used for a long period !
Find Quality Products Online at:
1.
Mono, D , LR20
GlobalTestSupply
www.
11
2.
7

Remote control

.com
sales@GlobalTestSupply.com
3
4a
17
18
19
3
Mignon
AA
LR6