Publicité
Les langues disponibles
Les langues disponibles
F. Lift glass door up and off edge of firebox top and slide it under top retainers to remove.
NOTE: When removing the glass door, a simple procedure must be followed in order to not damage the components.
1
2
G. Slide glass door under top retainers and rest on edge of
firebox. Swing bottom inwards.
I. Set cast front over legs and reinstall bolts removed at step B
until secure.
J. Place cast top on top of appliance.
NOTE: If gap adjustment is required between cast front and side, tighten or loosen wing nut screws (located be-
hind either side on the bottom).
5.4
glass / door replacement
WARNING
!
•
Do not use substitute materials.
•
Glass may be hot. Do not touch glass until cooled.
•
Care must be taken when removing and disposing of any broken door glass or damaged components. Be
sure to vacuum up any broken glass from inside appliance before operation.
•
Do not strike, slam, or scratch. Do not operate appliance with glass removed, cracked, broken, or scratched.
Replacement glass/frame assembly shall be replaced as a complete unit as supplied by the appliance
manufacturer.
THIS TEMPLATE MUST BE USED WITH 38.1
H. Slide 'T' latches into grooves at bottom of glass and
fasten release handles.
38.1
finishing
38.1.1
W415-4084 / A / 06.01.22
EN
35
Publicité
